If the water is cloudy, it will clear up after it sits for a short time. Cloudiness in the water is caused by air in the distribution lines. However, cloudiness that does not dissipate may be calcium. If you have this problem, please call Water Quality at 219-462-6174, Option 5.
Show All Answers
This depends on temperature conditions. We adjust the amount of chlorine at the plants daily. When the air temperature gets warmer, we have to increase the chlorine level because heat will dissipate the chlorine. The water smells because as we adjust the level up and the air temperature cools, more chlorine will remain in the water than if the air temperature had stayed warmer. There is no harm in drinking the water. If you have any questions, please call Water Quality at 219-462-6174, Option 5.
If you have rust-colored whites due to brown water, a rust stain remover such as Iron Out will remove the discoloring.
Possible causes for low pressure in your house might be: - A plumbing problem - Screens on the faucets are plugged - The main valve at the water meter is off or partially off Possible causes for low pressure in your area might be: - A main break in your area - A major fire - Water main construction work - Water main maintenance work If you are experiencing low pressure problems, please contact the Customer Service Department at 219-462-6174, ext. 1322.
There are 23 to 28 grains per gallon of water. Iron levels discharged from the treatment plants are from 0.03 to 0.06 milligrams per liter or parts per million. Iron levels can be higher due to the iron pipes in the distribution system. On rare occasions, problems in the filtration process can cause higher levels of iron to be discharged from the treatment plants. Fluoride is added to our water. The levels of fluoride are kept around 0.7 milligrams per liter or parts per million. Chlorine is added to disinfect the water. Chlorine levels vary depending on the distribution system. The chlorine levels in the water discharged from the treatment plants ranges from 1.2 to 1.5 milligrams per liter or parts per million.
Brown water is caused by iron and other materials stirred up in the water mains. This can be caused by a water main break, Street Department street sweepers pulling water from the hydrants, or Water Department crews flushing out hydrants, etc. The water is safe to drink, but do not wash whites, since the clothes will become discolored. If you are experiencing this problem, simply turn on any cold water faucet (do not turn on the hot water faucet), and let the cold water run for a few minutes. This should clean out the residue in your service line. If the water does not clear up, please contact Water Quality at 219-462-6174, Option 5.